Precision machining

inquiry.ch@made-parts.com
 Precision machining —— Good faith cooperation , Be even quality
Your location : Home > Information Center

Information Center

+86-755-27269220
 What are the problems in the use of the equipment in the parts processing customized service center

The equipment in the customized service center for parts processing includes ...

   Customized service center for parts processing , Equipment of precision mechanical parts in use , The following problems are inevitable :  1、 Waste water 、 Waste liquid : Such as oil 、 Filth 、 Heavy metals Waste liquid , In addition, there are cooling and drainage with high temperature, etc ;  2、 Noise ...
 Precision machining  Manufacturer's screw locking mechanism

Precision machining Manufacturer's screw locking mechanism

   Chart 6-3 Screw type locking mechanism shown 。 As Chart 6-3(a), In the process of high precision parts customization , When turning the rotating cylinder clockwise 3 Time screw 4 Rotate and move down axially , Pass the ball 8 Push sleeve 7 Upper cone 9, Open both sides of the long end of the two levers ...
 Precision machining  Of  Compressor body  And motor

Precision machining Of Compressor body And motor

   Stay Precision machining In process , Compressor body ( As Chart ) The compressed air is sent out by compressing the air inhaled with a screw , If the air compressor body is not maintained, the bearing will be damaged due to consumption ( Body bite ), It can't be repaired in case of severe damage , Even repair ...
 Maintenance and replacement of oil gas separator in precision parts processing plant

Maintenance and replacement of oil gas separator in precision parts processing plant

   In precision parts factory , Oil gas separator ( As Chart ) It is a part that separates screw lubricating oil and compressed air , In normal parts processing / Accessories processing in operation , Oil gas separator Of Service life Stay 3000 Hour or so , But the quality of lubricating oil and the air ...
 Why granite should be selected as the guide table of parts processing factory ?

Why granite should be selected as the guide table of parts processing factory ...

   Familiar with machining of mechanical parts , The shape of guide rail is right angle , Add anti dumping and force sealing structure or rectangular guide rail 。 In the parts factory , Their worktable ( Base ) And guide rails in all directions are made of natural granite materials 。   According to parts and components ...
cache
Processed in 0.031472 Second.